iFixit - Answers With Device "Coffee Maker"

Impressa A9: не молит кофе совсем

Tue, 07 Apr 2026 09:14:16 -0700

машина не молит кофе

Keurig Elite: My Keurig Will not draw water

Sat, 18 Apr 2026 14:24:13 -0700

My Keurig shows out of water but will not draw water from the reservoir

⟐ Commented апреля 18, 2026 at 14:24 GMT-7

DeLonghi ETAM Series: How do I remove the safety guard from the grinder

Sat, 18 Apr 2026 11:04:32 -0700

Mgnifica evo ecam290

⟐ Answered апреля 18, 2026 at 11:04 GMT-7

Melitta Caffeo Barista T: Not delivering coffee and leaking clean water

Thu, 16 Apr 2026 09:27:24 -0700

My machine is grinding the beans, then goes through the motions to make coffee but at the point it would deliver coffee nothing happens you can hear a soun from the exit hole but nothing come out, then it froths and delivers the milk.the grounds are wet and hot but then water leaks from under the tray. The water is clean doesn’t look like it’s been through the beans. I’ve cleaned the brewing unit run descaling

edit

I managed to get it working but it’s started again. It grinds, sounds like it producing coffee, but no coffee is produced, water is in the tray and underneath the unit with very wet grounds in the bin. I’ve tried changing the grounds finer and courser. I’ve tried using ready ground coffee it’s doing the same. I’m googled eyed with googling for answers.

⟐ Commented апреля 16, 2026 at 9:27 GMT-7

Keurig K-Duo: My Keurig doesn't want to reset after discale

Tue, 14 Apr 2026 11:50:33 -0700

How can I reset after discale

DeLonghi ETAM Series: waartoe dient de microschakelaar in de bovenste brouwzuiger?

Tue, 14 Apr 2026 11:22:32 -0700

function of the microswitch?

Siemens EQ6: My grinder motor burned stuck. New motor assembly installed not workin

Sat, 11 Apr 2026 07:15:53 -0700

My grinder got stuck and burned out. I can see from outside the motor all the wires burned inside. I bought a new motor assembly (with cables and everything) and did a swap. Now new grinder does not move at all , The machine does full coffee preparing process but only water comes out.

Can this be the same mosfet burnt that makes the grinder run forever or should i look for something else?

Nespresso Delonghi Lattissima Touch: Latissima Touch - Fails to complete the descaling process

Fri, 10 Apr 2026 05:29:41 -0700

Tried to descale the machine (when prompted by the flashing light).

Descaling cycle completed, but after filling the tank with fresh water the machine switched off when the froth button was pressed to start the rinse cycle.

Tried to run the whole process three times - no change.

So can't complete the rinse and the descale light continues to flash.

Any similar experience and suggested fix out there?

Siemens Coffee Maker: Touch Display not working on Siemens EQ500

Thu, 09 Apr 2026 08:28:26 -0700

Hello

Only the on/off button works on my touch display on Siemens EQ500. Any idea how to fix it?

Keurig Elite: My Keurig makes brewing noises but doesn't brew.

Thu, 09 Apr 2026 04:19:31 -0700

Lately, my Keurig Elite hasn't been making full cups of coffee, and just today it finally decided that it no longer wants to brew anything at all. I'm at a loss... Is this thing salvageable?

⟐ Commented апреля 09, 2026 at 4:19 GMT-7

Philips EP2200: Milk frother not working properly

Tue, 07 Apr 2026 16:21:30 -0700

My steam point for frothing milk seems to not have enough power? Hardly even warms the milk

Nespresso Vertuoline: Light blinking two times, pause, two times, etc.

Tue, 31 Mar 2026 11:48:26 -0700

How can I resolve the two-blink error on this machine without returning it?

⟐ Commented марта 31, 2026 at 11:48 GMT-7

Lavazza Coffee Maker: Water in machine sign on display

Sun, 29 Mar 2026 09:10:26 -0700

The display on my coffee maker is showing an orange water indicator. I have emptied everything.

Is there water inside the machine somehow?

DeLonghi ESAM xxxx - (Different Types): Magnifica inside gear not working.

Sun, 29 Mar 2026 08:36:27 -0700

It had problems before. Then when I tried to fix it it got completely stuck when the inside gear was ‘winding up’.

Saeco Odea: Machine won't prime. How do you remove the water pump

Sun, 29 Mar 2026 02:21:38 -0700

I have the machine open but can't figure out how to remove the water pump

⟐ Answered марта 29, 2026 at 2:21 GMT-7

Cuisinart DCC-1200: On and off switch

Fri, 27 Mar 2026 11:20:01 -0700

Why does my On and off switch turns off during brewing?

⟐ Commented марта 27, 2026 at 11:20 GMT-7

DeLonghi Dedica EC680: Pump sounds but no water from portal filter

Thu, 26 Mar 2026 15:05:41 -0700

We have a 9-year-old EC680 and suddenly the portal filter is not fed. At 06:00 I took a shot, at 13:00 only the pump sounded but no water appeared at the portal filter. After some seconds the pump turned off, because no water was flowing. No strange LEDs. Sadly I did no further tests.

This night I disassembled the machine until I could slide the inner parts out, powered -> only pump sounds, disconnected the flowmeter, powered -> suction on the pipe! I've opened the flowmeter, it's clean. Reconnected flowmeter, suction. Because there was no longer any fault I assembled the machine, powered -> no water. Then I switched to steam and this worked (unfortunately I didn't try this before disassembling). And afterwards even the portal filter got water.

So ... even in case the EC680 will brew next morning ... what was the fault / which parts should I replace when I get the fault again? I've seen the disassembling video and perhaps that small ball got stuck in the housing? The higher pressure of the steam setting got it loose? Any other idea?

Best regards, Vitus

Keurig K55: Why is my Keurig Classic constantly turning off while brewing?

Thu, 26 Mar 2026 09:57:51 -0700

I put the Keurig brand K cup in, pull down the top, and press the brew button. It works for a split second then the machine turns off and I waste a K Cup. The K Cup just leaks into my cup and I have to remove it and try again because if I try and use the same K Cup it doesn’t taste right! It happens with numerous Keurig branded K Cups including Hot Chocolate, Cafe Caramel, and Cafe Vanilla. It’s been happening at least 3-4 times a week.

This is my third machine I’ve received from Keurig support and it’s still happening. I’ve done all the needle cleaning, reseting, descaling, and many other fixes. The unit is not even 3 months old.

I’m just at a loss of what to do because I don’t see many people having the same problem. I’m also sick and tired of wasting perfectly good K Cups! Anybody have ideas how to permanently fix this?

EDIT & SOLUTION: I've been able to resolve the issue using a work around. This is not a fix and I don't know why Keurig hasn't fixed it after years of this happening.

When using a milk based K Cup, press it into the bottom by hand so the K Cup is punctured. Pull it up and rotate 90º and close the lid. This gives the K Cup two holes and much less pressure. It has worked perfectly since I've been doing this.

⟐ Commented марта 26, 2026 at 9:57 GMT-7

Keurig K-Mini: Its does not turn on, no lights

Sun, 22 Mar 2026 10:45:59 -0700

Got this new but when i plug it in, it does not turn on anymore. Heard a bang after plug-in. Seems its only 110 and i plugged it in with 220v. Anyway this can be fix?

⟐ Commented марта 22, 2026 at 10:45 GMT-7

Keurig K70: Keurig shuts off right after I press brew, and the menu option is dead

Wed, 18 Mar 2026 09:11:07 -0700

OK OK I bought it at a thrift store BUT it is really clean, someone took care of it. I would feel great if I can resurrect this baby before surrrendering it to electronic waste.

⟐ Answered марта 18, 2026 at 9:11 GMT-7