Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Помощь

Оригинальный сообщение: oldturkey03 ,

Текст:

Giovanni Riva, take a look at the schematic from your precious question. Pin1 and 14 are the power button. Since it is a switch, you will not need to apply any power to the connector. You need to connect from point to point, in this case 1 to 14 should turn the power on. Placing a jumper across the other pins should also close the USB circuits. Pin 5-10 seem to relate to the charging circuit.  Do not apply any additional power to the connector at all. Hope this helps, good luck.

[image|239490|align=left]

Статус:

open