Перейти к основному содержанию

Оригинальный сообщение: jessabethany ,


Hi Rany,

Is it recognized by USB in that state?  It may be possible to use some kind of third party software like iTools to read the real time log.

This is probably going to be drop damage to the PMIC and it just isn't outputting the right signal :(  The only solvable thing that I can think of is just bad battery.  If any iDevice fails to receive the input from the battery of the battery temp, and the battery gas gauge--it shuts off.

A failure in these lines can come from the battery itself, or some damage to the board that broke continuity in the line (not on the radar screen if the iPad was unopened prior to the problem)

Side note:  check out iFixit meta---I passed your Troubleshooting section idea over there.  Apparently we already are doing this!