Skip to main content
Help

Original post by: Robert B Kinnick ,

Text:

Just recently fix my headset Turtle Beach P11 because my kids destroyed the 4 pole connector. Took awhile to figure out what went where after dissecting the old connector. There are 6 wires (red, green, blue) all of which are ground wires that is covering a secondary sleeve (Red, Blue, White).

Pin 1 (TIP, Left audio) Red sleeve (burn a little bit of the tip off but do not expose the whole wire.)

Pin 2 (Right audio) Blue sleeve (burn a little bit of the tip off but do not expose the whole wire.)

Pin 3 (Ground) Twist red, green, and blue wires together. Solder to the connection point.

Pin 4 (Mic) White sleeve (pull through the whole on the sleeve. Solder and cut the excess off.)

Status:

open