Перейти к основному содержанию
Помощь

Оригинальный сообщение: Abrsvc ,

Текст:

Based upon hte pictures provided, you did not remove the connector from its mate, you removed both at the same time from the board.  It also appears that one of the leads has also been broken.  The connector on the power supply itself must be replaced.  If you do not have the capability to do this, replace the entire power supply which will have the connector in place.  Note: the end of the cable being held in the last photo needs too have the housing removed.  If you look carefully, you will see that you have both the male and female connectors at the end.  These must be separated.

Dan

Статус:

open