Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Помощь

Оригинальный сообщение: Reynault ,

Текст:

Change of plans.  I just swapped out the boosted v1's original electronics with something else.  I took out the 39.6 volt battery with the BMS and took out the esc (circuit board)

Currently I am using a 24/36 volt esc I got from eBay and I am using a Ryobi 40 volt 6.0 ah lithium battery.

I ran it Thursday night (8/13). it ran pretty good.   I am sharing the motor wires from each motor for the single connection.

In other words 2 motor wires from each motor are into each if the 3 connections.

And I have to run it without the hall sensors. Because for some strange reason, when the hall sensors are plugged in, I can not turn on the power….. however with the hall sensors unplugged, I can turn on the power.

Other than that, it runs pretty decent.  Only thing is jerky take off.  I think its because there is no hall effect.

Статус:

open