Перейти к основному содержанию
Помощь

Текущая версия: Aiden Baker ,

Текст:

DAveDave, according to the service manual there are a few possibilities
DAveDave, according to the service manual there are a few possibilities
 
Sud - SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)
 
The motor control unit senses a suds lock condition by analyzing the current draw on the drive motor. If “Sud” is displayed a potential suds lock is detected. This may signify a bad pump, an extra heavy load, excessive detergent, or excessive suds.
 
• If too much detergent was used, run the unit through a Rinse/ Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent.
 
• Check the drain hose and make sure it is not plugged or kinked
 
• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
 
• Check/ Clean Drain Pump Filter of foreign objects
 
• Check Drain Pump
 
• Check the Pressure Switch
 
• Check CCU
 
To make your job easier, try to download the manual from the bottom of [[Topic:Kenmore Elite HE3 Washing Machine|this page]] Good luck and I hope it helps.
 
=== Update (09/26/2015) ===
 
Here is an image showing the location of the pressure switch [image|640187

[image|640187
]
Here is an image showing the location of the pressure switch [image|640187

[image|640187
]

Статус:

open

Отредактировано: oldturkey03 ,

Текст:

DAve, according to the service manual there are a few possibilities
 
Sud - SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)
 
The motor control unit senses a suds lock condition by analyzing the current draw on the drive motor. If “Sud” is displayed a potential suds lock is detected. This may signify a bad pump, an extra heavy load, excessive detergent, or excessive suds.
 
• If too much detergent was used, run the unit through a Rinse/ Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent.
 
• Check the drain hose and make sure it is not plugged or kinked
 
• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
 
• Check/ Clean Drain Pump Filter of foreign objects
 
• Check Drain Pump
 
• Check the Pressure Switch
 
• Check CCU
 
To make your job easier, try to download the manual from the bottom of [[Topic:Kenmore Elite HE3 Washing Machine|this page]] Good luck and I hope it helps.
To make your job easier, try to download the manual from the bottom of [[Topic:Kenmore Elite HE3 Washing Machine|this page]] Good luck and I hope it helps.
 
=== Update (09/26/2015) ===
 
HereHere is an image showing the location of the pressure switch [image|640187]
HereHere is an image showing the location of the pressure switch [image|640187]

Статус:

open

Отредактировано: oldturkey03 ,

Текст:

DAve, according to the service manual there are a few possibilities
 
Sud - SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)
 
The motor control unit senses a suds lock condition by analyzing the current draw on the drive motor. If “Sud” is displayed a potential suds lock is detected. This may signify a bad pump, an extra heavy load, excessive detergent, or excessive suds.
 
• If too much detergent was used, run the unit through a Rinse/ Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent.
 
• Check the drain hose and make sure it is not plugged or kinked
 
• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
 
• Check/ Clean Drain Pump Filter of foreign objects
 
• Check Drain Pump
 
• Check the Pressure Switch
 
• Check CCU
 
To make your job easier, try to download the manual from the bottom of [https://www.ifixit.com/Device/Kenmore_Elite_HE3_Washing_Machine|this page[Topic:Kenmore Elite HE3 Washing Machine|this page]] Good luck and I hope it helps.

=== Update (09/26/2015) ===

Here is an image showing the location of the pressure switch
To make your job easier, try to download the manual from the bottom of [https://www.ifixit.com/Device/Kenmore_Elite_HE3_Washing_Machine|this page[Topic:Kenmore Elite HE3 Washing Machine|this page]] Good luck and I hope it helps.

=== Update (09/26/2015) ===

Here is an image showing the location of the pressure switch

Статус:

open

Отредактировано: oldturkey03 ,

Текст:

DAve, according to the service manual there are a few possibilities
 
Sud - SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)
 
The motor control unit senses a suds lock condition by analyzing the current draw on the drive motor. If “Sud” is displayed a potential suds lock is detected. This may signify a bad pump, an extra heavy load, excessive detergent, or excessive suds.
 
• If too much detergent was used, run the unit through a Rinse/ Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent.
 
• Check the drain hose and make sure it is not plugged or kinked
 
• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
 
• Check/ Clean Drain Pump Filter of foreign objects
 
• Check Drain Pump
 
• Check the Pressure Switch
 
• Check CCU
 
To make your job easier, try to download the manual [http://www.keepandshare.com/doc/3017969/duet-aid-also-kenmore-he3-pdf-july-30-2011-8-04-pm-1-5-meg?da=y|from here.] Goodfrom the bottom of [https://www.ifixit.com/Device/Kenmore_Elite_HE3_Washing_Machine|this page] Good luck and I hope it helps.
To make your job easier, try to download the manual [http://www.keepandshare.com/doc/3017969/duet-aid-also-kenmore-he3-pdf-july-30-2011-8-04-pm-1-5-meg?da=y|from here.] Goodfrom the bottom of [https://www.ifixit.com/Device/Kenmore_Elite_HE3_Washing_Machine|this page] Good luck and I hope it helps.

Статус:

open

Оригинальный сообщение: oldturkey03 ,

Текст:

DAve, according to the service manual there are a few possibilities

Sud - SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)

The motor control unit senses a suds lock condition by analyzing the current draw on the drive motor. If “Sud” is displayed a potential suds lock is detected. This may signify a bad pump, an extra heavy load, excessive detergent, or excessive suds.

• If too much detergent was used, run the unit through a Rinse/ Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent.

• Check the drain hose and make sure it is not plugged or kinked

• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)

• Check/ Clean Drain Pump Filter of foreign objects

• Check Drain Pump

• Check the Pressure Switch

• Check CCU

To make your job easier, try to download the manual [http://www.keepandshare.com/doc/3017969/duet-aid-also-kenmore-he3-pdf-july-30-2011-8-04-pm-1-5-meg?da=y|from here.] Good luck and I hope it helps.

Статус:

open