Перейти к основному содержанию

Обновленная версия iPhone 3G с более высокой скоростью обработки. Ремонт этого устройства схож с iPhone 3G, и требует простых отверток и инструментов для вскрытия. Модель A1303; 16 или 32 ГБ памяти; с Черной или Белой задней пластиковой крышкой.

1963 Questions Показать все

My screen dose not work

My 3GS screen dose not work. When I flip the vibrate switch I get a vibration. Just that the screen dose not work, it stays pitch black. Could this be a problem with the LCD or the connected on the logic board?

Update

I had already taken it apart and I looked at the connectors for the LCD and the connector on the logic board. Here is what they look like. Which one is broken?

Block Image

http://imgur.com/Bd2XEKm,rZIwt3i#0 SCREEN

Block Image

http://imgur.com/Bd2XEKm,rZIwt3i#1 LOGIC BOARD

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

по рейтингу 0

Комментарии:

This should be a more brighter picture of the logic board. I took it out and gave it a brush. http://imgur.com/xqmWX4O Dose the solder on the side matter?

by

which solder on what side? Looks like bottom left of your logic board connector is not quite right, but difficult to make out.

by

Добавить комментарий

Android Fix Kits

A new screen or battery is one kit away.

Купить сейчас

Android Fix Kits

A new screen or battery is one kit away.

Купить сейчас

2 Ответов

You can check the connectors between the display and the logic board and ensure it's connected by following this guide. If it still doesn't work then it could either be the logic board or the display. The best thing to do at this point is to find a friend with an old 3Gs and swap display! If it works, then the old display is broken. If it doesn't work, then it's the logic board. You can find the display here and the logic board here.

Был ли этот ответ полезен?

по рейтингу 0
Добавить комментарий

Peter Zhao, take a look at the image you posted. The connector from your LCD flex definitely looks like it got all shewed up. Looks like at least 2 contacts that are missing (your image top right corner of the connector." You might want to replace that since it will be easier than the one on your logicboard. That particular image is a bit dark on the right lower corner, but it appears that the contacts are all there.

Был ли этот ответ полезен?

по рейтингу 0
Добавить комментарий

Добавьте свой ответ

Peter Zhao будет вечно благодарен.
Просмотр статистики:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

За всё время: 214