Перейти к основному содержанию

Fourth generation of iPad, released November 2, 2012, available in 16, 32, or 64 GB models. Model Number A1458

217вопросов Показать все

I mistook the home button ribbon cable connector

I have broken off the square 5 wire connector next to the home button ribbon cable, and all the soldered leads are no longer attached. How to repair?

I have attached two pictures from the guide. I mistook the connector as the picture was a little too small to see, only after "prying up the flap" did I discover I pried up the soldered connector.

Is this repairable or have I junked my new iPad 4th ten pride and joy?

Here are pictures where the connector is shown as right next to the cable connector…

Block Image

Block Image

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 1
Добавить комментарий

1 ответ

The connector can be replaced but the leads may need to be re-routed. It is a difficult repair, you could ruin it further if not done carefully

Был ли этот ответ полезен?

Оценка 0

1 Комментарий:

I just found a repair service who will solder a new connector to my logic board for $50 plus shipping. Will advise once I have it back in house.

из

Добавить комментарий

Добавьте свой ответ

Al Taylor будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 425