Replaced LCD, only get a backlight?

Question

iPad 2 Wi-Fi EMC 2560

Updated version of the original iPad 2, released in March of 2012 with a smaller die processor and updated internal construction. Repair will require the use of heat and careful prying.

73вопросов Показать все

Вопрос закрыт

Stephen @stephen70901

Репутация: 1

Опубликовано: 12 фев 2014 г.

Опции

Replaced LCD, only get a backlight?

Hi,

My Ipad 2 2012 got pretty smashed up, i dismantled and the parts i needed were digitiser, lcd screen, power flex ribbon and headphone jack ribbon (runs from power flex and goes into logic board)

I have put it together and tested it and with the ipad plugged in i can see the backlight, i can also see it working when i try sticking it in dfu mode and recovery mode.

restores will not work as i keep getting errors (21,3194,3004) but it is being recognised by itunes.

does this sound like a hardware issue or software issue?

thanks :)

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Да Нет

Оценка 0

Добавить комментарий

2 Ответов

kerri @kerri64459 Репутация: 329 6 2 1 · Answer 1 · 2014-02-16T06:47:34-07:00

kerri @kerri64459

Репутация: 329

6

2

1

Опубликовано: 16 фев 2014 г.

Опции

Sounds like both, the backlight issue could be the result of not turning off the iPad before disconnecting the digitizer and LCD. That's called perm dim. It requires changing a chip and coil and intricate solder work. Did you try a hard reset? Holding down the menu and power button at the same time?

Был ли этот ответ полезен?

Да Нет

Оценка 0

Добавить комментарий