Volume + Mute + Power Buttons & Right Speaker not Working!
Basically I dropped my iPhone into the Bath a week ago. Here's what course of action I took:
#1) Grabbed phone and removed it (was not submerged for more than 2 seconds)
#2) I held the power button to turn it off but the screen was not responding
#3) I ran upstairs and unscrewed the bottom two screw and lifted out the screen, followed by the logic board and dismantled the screen from the glass.
#4) Then I used a hair-dryer on a fast but warm air cycle to dry for around 20 minutes and afterwards left the parts to dry separately for around 4 days.
The result is a fully functioning iPhone 3G for afterwards. However my screen had white bits for a few days but now its entirely dry.
HERE ARE THE PROBLEMS!!!
For about five days the phone was working fine until a few days later the power + volume + mute buttons stopped working and my phone is stuck on full volume which is very annoying whilst I'm in lessons. Also when I bought the phone the right hand side speaker near the dock of the iPhone did not work, only the left one functioned.
I didn't really care about the broken speaker but now I may as well try and fix it since I'm going to have to fix the iPhone non functioning Volume + Power + Mute buttons.
I have ordered a new headphone jack assembly because I have read that the reason my buttons don't work is due to this part.
So once I attempt to repair that I might as well try and fix my speaker.
My question is... How do I replace/Repair my loadspeakers???
Это хороший вопрос?