Hi
I attempted to replace a broken screen and had nothing displayed w ith the new screen. I had broken off the digitizer connectors by accident not sure if this was the problem or screen was DOA. I then broke one of the arms of the bracket that holds the pressure connector .
Any advice appreciated!
Это хороший вопрос?
Репутация: 199
3
There are two possible fixes.
1 - This method will take trial and error and is not guaranteed to work, but it will be by far the easiest solution.
Try to find a thick tape and maybe a foam spacer and place it where the arm bracket should be also make sure its applying a little pressure on the component with the LCD ribbon inside. This has work for me many times on Blackberry's and HTC Evos.
2 - This is the legitimate method, guaranteed to work (if done right), but has a very high level of experience needed.
You have to buy the whole connector that goes mounted onto the board. Unsolder the broken one and solder the new connector. This part has A LOT of pins, unlike a charging port or power button so diligence and patience will be a virtue. If you don't have the equipment, I would order the parts (which are maybe $3-$7 but can be hard to find) and take them to a local repair shop that does mother board repairs (since its unlikely they will carry that in their inventory).
Был ли этот ответ полезен?
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 0
За всё время: 268
