Convert dead iMac to a Monitor?

The Answer I hope is yes. I have a controler board NT68676 2A 1256 which has vga hdmi and

dvi-d inputs with audio. a simple 4 button control board plus a cable to go between the controller and LCD panel cost around $30 from ebay.com cost me a bit more as I am in UK.

The above controller is normaly use for smaller panels and supplies 12v to power the inverter for the LCD panel. I asked the supplier if I could provide the 24v for the iMac inverter would his controller board be able to handle the signal side of things, he's said it would.

I am looking with no luck yet to find the pinout for the power supply as from the work done on earlier versions G5 and 20 inch it would seem I will have to ground 1 pin on power supply to switch it on. if anyone knows the answer or has already done this would be most grateful if you could share it.

I have today found this pinout from a power supply in the off state but possibly faulty, so if any one could supply pin out for the on state would be great

PIN V

1 GND

2 +12

3

4 4

5

6 GND

7 GND

8 +12

9 +12

10 +12

11

12 GND