Репутация: 275
3
14
I inadvertently broke the flex cable of my home button while lifting up the screen.
I read that a replacement home button will NOT allow me to use Touch ID anymore.
Is it possible to repair, maybe solder the flex cable that I broke?
Это хороший вопрос?
Репутация: 379
4
It is impossible sadly. They are directly correlated with the logic board for security reasons and if you break one you're out of luck. You could try and find a new logic board with a home button but that might be costly.
Был ли этот ответ полезен?
Репутация: 73,8к
19
111
82
Репутация: 25
1
1
Got the exact same problem, two different answers...
@Rocket Repair: so basically the cable itself is linked with the logic board and not the Touch ID sensor? That means hypothetically you could change the home button if you keep the original cable?
Был ли этот ответ полезен?
Репутация: 2,9к
27
10
10
If it's just a broken flex cable then with a lot of patience they can be bridged with fine wire. It was done on a camcorder so maybe similar, see this video
Был ли этот ответ полезен?
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 1
За всё время: 285
