Перейти к основному содержанию

The Apple Magic Mouse is a multi-touch mouse manufactured and sold by Apple Inc. It was announced and sold for the first time on October 20, 2009.

48вопросов Показать все

How do I reattach the capacitor board to get touch capability?

My magic mouse came apart after dropping it. I put it back together and I am able to point and click with it, but I lost the "magic" touch capability for scrolling, etc. I think it's because the orange tab that is part of the capacitive touch sensors isn't connected to the circuit board in the mouse. Can someone tell me how to re-attach it properly? It would be MUCH appreciated... :)

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 2
Добавить комментарий

2 Ответов

Наиболее полезный ответ

This is probably the most difficult procedures for repairing the Magic Mouse. The reason isn't so much because it is difficult technically. The Ribbon cable just slides in to the attaching point. The problem is it is in a odd position with little room to hold the cable. You will need a small thin set of needle nose pliers or hemostats. Attach the hemostats to the ribbon cable near the middle of the cable (enough to hold the cable stiff. Align the cable with the slot and try to push the cable in. Once it is in be careful not to pull it out again. Put the mouse back together and it should work fine. Follow the instructions in ifixit Magic mouse tear down procedure.

Был ли этот ответ полезен?

Оценка 1
Добавить комментарий

...or see this Video on YouTube

You can achieve the same result also without breaking nothing. You have only to raisen the black plastic parts a little bit and extract the ribbon cable:

Block Image

Был ли этот ответ полезен?

Оценка 0
Добавить комментарий

Добавьте свой ответ

Sheilah будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 2

За последние 7 дней: 6

За последние 30 дней: 25

За всё время: 3,176