Второе поколение iPhone. Модель A1241; 8 или 16 ГБ памяти; с черной или белой задней пластиковой крышкой. Ремонт проще, чем первого iPhone. Требует отвертки и инструментов для вскрытия.

1500 Questions Показать все

My LCD screen is not working

I bought a Screen panel kit because I dropped my Iphone 3G and the screen shattered but the LCD was still working fine and I could still touch the screen and use my Apps. Before installing the new screen I took the Iphone apart to see how to do it by following the instructions but when I did that and connected the still broken screen, My LCD screen does not turn on. When I plug it up to charge the screen turns Yellow! and I can still hear the beep noise it makes when you put it to charge

Отвечено! View the answer У меня та же проблема

Это хороший вопрос?

по рейтингу 0
Добавить комментарий
Spread Fixmas Cheer
Получите $12 за покупку от $50 и выше с промокодом FIXMAS12
Spread Fixmas Cheer
Получите $12 за покупку от $50 и выше с промокодом FIXMAS12

4 Ответов

Выбранное решение

make sure you turn the phone off first (hold power button until slide to power off) or you'll burn out the back light and no lcd will work!

Был ли этот ответ полезен?

по рейтингу 2

Комментарии:

Thanks but I was able to fix the problem... All i needed to do was to reset my Iphone with the center button and the lock button

от

Right! The LCD is not plug-and-play compatible. Your need to restart the phone after connecting it. Hold HOME+POWER Button till it restarts.

от

Добавить комментарий

Hi,

open your iphone again, and disconnect touchscreen cable from the motherboard. Then try to switch on your iphone, and check if there are any changes. Please let me know result.

Thanks.

Был ли этот ответ полезен?

по рейтингу 0

Комментарии:

Thanks but I was able to fix the problem... All i needed to do was to reset my Iphone with the center button and the lock button

от

I had the same problem after replacing the battery. A simple full reset of the phone did this for me. Holding down the HOME+POWER for 10 seconds did the trick. Thanks guys.

от

Добавить комментарий

i have a similar problem my iphone screen looks fine works fine but i press the left side of the phone and it turns white what could be the cost of this

Был ли этот ответ полезен?

по рейтингу 0

Комментарии:

Raul, your question appears as an answer to a 1year old question. It would be better if you click on the link on the right side of this page" Ask a Question" and give as much detail as possible. Then the iPhone gurus on here will see that you need some assistance. Good Luck

от

Добавить комментарий

HELP! i tried the POWER+HOME method and the screen still will not light up. i replaced the digi and the screen and now it wont light up. i tried what i saw in your forum but its still not working. what do i need to do? this is the third screen ive put on it and they all will not light up. (Phone was dead/off during the repair)

Был ли этот ответ полезен?

по рейтингу 0
Добавить комментарий

Добавьте свой ответ

Joel будет вечно благодарен.
Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 0

За всё время: 6,038