Перейти к основному содержанию

Дата выхода 19 сентября 2014 года. Это маленькая версия iPhone 6 Plus с 4.7-дюймовым экраном.

4994вопросов Показать все

Replacing iPhone 6 home button ribbon cable (error 53)

Recently while replacing my iPhone 6 screen, I ripped the bottom connector of the home button ribbon cable at the bottom of the LCD heat shield. I proceeded to buy a replacement LCD shield with a built in ribbon cable, and installed it. It instantly went into an infinite loop of the apple boot logo and a flashing red screen. I immediately took it off and installed the original shield with the ripped connector and the phone went back to working fine minus the home button which obviously doesn't work. The phone is running iOS 10. I have a few questions:

1. Will updating the phone in this current state (with a disconnected/ripped home button cable) brick the phone with an error 53?

2. Will replacing the cable with a better quality ribbon cable or LCD shield make the phone work or will this result in an error 53?

3. If this does work, will updating the phone with the new cable/shield result in an error 53?

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Оценка 0
Добавить комментарий

1 ответ

Выбранное решение

You'll be fine with any updating, error 53 has been removed by Apple and only ever applied to replacing the home button not the ribbon cable on the LCD shield. Boot loop and flashing red was likely caused by the new LCD shield being faulty and should just be a matter of getting a new one.

Был ли этот ответ полезен?

Оценка 3
Добавить комментарий

Добавьте свой ответ

Andrew Berend будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 130