The first generation of the Chevrolet Equinox, a crossover SUV from Chevrolet based on General Motors' Theta platform.

85 Questions Показать все

Changing the license plate light bulbs

I need to change the license plate light bulbs, however I cannot remove the plastic cover. It appears that I have to remove many other parts. The owners manual does not show how to do this.

Отвечено! View the answer У меня та же проблема

Это хороший вопрос?

по рейтингу 1
Добавить комментарий
Spread Fixmas Cheer
Получите $12 за покупку от $50 и выше с промокодом FIXMAS12
Spread Fixmas Cheer
Получите $12 за покупку от $50 и выше с промокодом FIXMAS12

5 Ответов

Выбранное решение

1

Open the Equinox's rear hatch. If you have an assistant who can hold the hatch in the half-open position, this task will be easier.

2

Remove the two screws from the lens cover of the lamp you need to replace, and remove the cover. The cover might be stuck to the rubber seal, requiring you to gently pry it off.

3

Pull the burned out bulb straight out of the socket, and replace it with a replacement bulb.

4

Replace the lens cover and insert the screws. Do not tighten the screws excessively or you may crack the cover

Был ли этот ответ полезен?

по рейтингу 1
Добавить комментарий

The bulb slipped up in the door, how do you get it back?

Был ли этот ответ полезен?

по рейтингу 1

Комментарии:

How far in the door did it go? You might use a wire to fish for it, otherwise you may have to remove the inside panel.

от

Добавить комментарий

Carry it to AutoZone, buy the bulbs, and they'll install the for free.

Был ли этот ответ полезен?

по рейтингу 1
Добавить комментарий

This is the easiest method, a little tight working area but it can be done. Took it to Auto Zone, their answer was that I would have to take it to the dealership. Only way is to remove the interior cover and pull the bulbs out and then place it back inside. Said it would cost around $75. Took it to American Lube, guy did the above method and had them replaced in about 5 minutes. No charge but I gave him something for helping me out.

Был ли этот ответ полезен?

по рейтингу 1
Добавить комментарий

When you pull off the clear plastic lens you will probably tear the gasket. Make a new gasket with some gasket material and re-install. You can also use a thin coat of silicon.

Был ли этот ответ полезен?

по рейтингу 0
Добавить комментарий

Добавьте свой ответ

booz bat будет вечно благодарен.
Просмотр статистики:

За 24 часа: 3

За 7 дней: 18

За 30 дней: 89

За всё время: 17,156