Tried fixing tristar iPhone 6s but ended with pulled pad
So yeah I've been watching alot of videos recently and decided to help some friends out who had some defect iphones, this one was iPhone 6S which would drain very quickly and would reboot itselves so I came to the conclusion that it was a defect tristar u2 ic
I have good desoldering tools but I lack a pair of good tweezers and good flux, solder wick.... and i think that is probably what &&^&@@ up the pads
I removed the old chip, the balls looked okay so i just put a new A3 chip on it and somehow it wouldn't fall in place, so i decided to remove the tins on the pads en ended up removing one the pads. and i also knocked over some cap or something not sure...
is this pad needed? if so how do i fix this as if dont have a clue how i would make a micro jumper
Это хороший вопрос?
1 Комментарий
Where can I buy or download this board schematic software?
из Jose Reyes