Перейти к основному содержанию

Repair guides and support for riding lawn tractors sold under the Murray brand name, currently owned by Briggs & Stratton.

139вопросов Показать все

Starts but won't stay running

I was given the mower, it's been sitting s while. So I've replaced battery, selenoid, cleaned air filter, new gas(was empty). If I spray started fluid in under the air filter it will start but won't run. I also put carburetor cleaner in the gas tank but a half dozen cranks later over the next 30 minutes it still won't start. Not sure how to get to the carburetor and how to clean it if I do. Looked through many diagrams here with no luck. Help!

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 1
Добавить комментарий

2 Ответов

You have a clogged carb, need to pull it off and clean it, most likely it is located under the seat if it is a mower like the one pictured. Also, if you follow the gas linie out of the gas tank it should lead you right to the carb.

Please post model #

Был ли этот ответ полезен?

Оценка 0

2 Комментариев:

Murray Select model number on motor is 283707. I think I see it behind the frame, where the gas line goes into it. There's a cup like cylinder on the bottom. I guess take the nut off that and clean?

из

https://www.ereplacementparts.com/briggs...

Take off part 975A, to see if the fuel is gummed up, etc...then post back.

из

Добавить комментарий

Remove carb. Clean carb and all internal parts float, jets, needle valve ect. Replace any gaskets if needed. Put carb back on and it'll run.

Был ли этот ответ полезен?

Оценка 0
Добавить комментарий

Добавьте свой ответ

Andy Dosdall будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 4

За последние 7 дней: 14

За последние 30 дней: 48

За всё время: 9,376