Перейти к основному содержанию

Обновленная версия iPhone 3G с более высокой скоростью обработки. Ремонт этого устройства схож с iPhone 3G, и требует простых отверток и инструментов для вскрытия. Модель A1303; 16 или 32 ГБ памяти; с Черной или Белой задней пластиковой крышкой.

1500вопросов Показать все

3Gs black screen after digitizer change

Hi, I had a 3gs that I replaced the digitizer after breaks. Whith the old digitizer the screen works but when I change the digitizer I had a black screen, I can answer the phone with the headphones and I can also hear at my mmusic with it, It also rings and i can see it on my computer, I replace the digitizer and the lcd but the same thing. What could be damage?

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Оценка -1
2 Комментариев

This question was migrated from http://meta.ifixit.com/.

из

Thank you for this tip, I did it and solve my problem.

из

Добавить комментарий

1 ответ

Выбранное решение

First thing I would do is a Hard Reset: Press and Hold both at the same time Top/Power Button and Home Button for about 20 seconds, keep holding and if it works the normal White Apple will show and it is fixed.

If not, then you may need to carefully open the iPhone up again and carefully seat (LCD) Cable #1 connector by pressing it to the Logic Board.

Before doing any of this make sure iPhone is OFF. To be certain iPhone is OFF move vibrate/mute switch, making sure it does not vibrate. Do not mess with the Cable #1 if the iPhone is possibly powered on.

Good luck,

Brad

Был ли этот ответ полезен?

Оценка 1
Добавить комментарий

Добавьте свой ответ

Robert Velez будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 1,871