Почините Свои Вещи Сообщество Магазин

Дата выхода 19 сентября 2014 года. Это маленькая версия iPhone 6 Plus с 4.7-дюймовым экраном.

4994вопросов Показать все

Опции

iPhone 6 boot loops (with red screen) - Please help!

Hello

my iPhone 6 is boot looping and sometimes showing a red screen for about a second.

What I’ve tried so far:

  1. booting phone with front camera assembly disconnected
  2. booting phone with battery disconnected
  3. replacing front camera assembly with a brand new one
  4. booting with home button disconnected
  5. booting with screen + home button + front camera assembly disconnected (iTunes will not detect the phone, PC will not detect the phone, assuming it was still boot looping)

I’m not sure what to try anymore. Everything looks fine on the inside.

When I try to boot the phone, the Apple logo appears, seems to go dimmer for a second (as if power was being sucked out of it), the logo disappears. This keeps repeating, with a red screen sometimes showing.

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Да Нет
Оценка 0
2 Комментариев

Try to put your phone in the refrigerator for about 20 minutes, dont forget to put it in a plastic sealed bag to prevent it from moister.

из

Not sure if you're serious or not, Leslie...

из

Добавить комментарий

1 ответ

Фильтр:
Самые полезные Самые новые Самые старые
Выбранное решение

Опции

Have you tried putting the phone into recovery mode and do an update and/or restore through there in an attempt to unbrick it?

Red Screen of Death after the troubleshooting you have done either points to corrupted firmware on the phone or a NAND flash eMMC chip failure (The memory chip on the logic board that holds user data and the iOS system firmware).

Hopefully it is just corrupted firmware meaning the phone will work normally again after updating or restoring the phone.

Worst case scenario the eMMC chip has gone bad and needs to be reballed, reprogrammed or even replaced which requires someone with board-level repairs / microsoldering experience to do.

To put an iPhone into recovery mode you hold the home button while it boot loops and is connected to computer until you see the iTunes logo. Then iTunes or 3UTools will prompt you that the iPhone is in recovery mode and needs to be updated or restored.

Try update first and if that fails try restore. Note that restore wipes all data on the phone.

Был ли этот ответ полезен?

Да Нет
Оценка 3

1 Комментарий:

Hello, thanks for the reply.

I've tried restoring the phone in both recovery mode and DFU mode.

I get error 4013 every time, which is apparently a hardware error?

Looks like I'm SOL.

из

Добавить комментарий

Добавьте свой ответ

Brink Laubscher будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 4

За всё время: 207