Перейти к основному содержанию

iPhone 7 plus был выпущен 22 сентября 2017 года и увидел свет в качестве двух модификаций: A1863, A1905. Поставлялся с двумя различными модулями мобильной связи: GSM или CDMA, а также с 64 Гб или 256 Гб встроенного хранилища. Цвет корпуса можно было приобрести золотой, серебристый или Space Gray.

869вопросов Показать все

iPhone 8 camera & flash not working

Hello, iPhone 8 working completely as normal except the rear camera and flash. Also torch function not working. Selfie camera works fine.

iTunes restore no progress. I can get a new camera and flash module so wondering if anyone had any thoughts? I believe it was dropped in water as I can see yellow stains on the bottom part of the screen…!

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Оценка 2
Добавить комментарий

1 ответ

Выбранное решение

If it was dropped in water, then you need to carefully inspect and decontaminate it if water did indeed get inside the housing. Unless you’re really lucky, the camera issue may only be the tip of the iceberg. Water damaged devices tend to have latent issues which will bite you when you least expect it. Make sure to get a good backup of the data if the water happened under your watch. If you bought this device as-is from someone else, then again, do a proper inspection and decontamination.

  • Open your phone and remove the logic board (follow this guide)
  • Inspect the logic board, especially around the connectors and look for corrosion.
  • Inspect both sides of the board. Unfortunately, most of the board is covered in shields. That's usually where the damage is occurring.
  • Put your board in a container with >90% isopropyl alcohol and let it sit for a while.
  • Use a soft brush, like a toothbrush and lightly brush away any corrosion you see.
  • Rinse in alcohol and repeat.
  • Let it air dry for a day.
  • Re-assemble and hope for the best.

Once this is done and the camera is the only remaining issue, you can replace it but check the camera connector on the logic board to see if there is any corrosion as there is usually corrosion there. Any physical damage to this connector will require a micro-soldering repair.

Был ли этот ответ полезен?

Оценка 5
Добавить комментарий

Добавьте свой ответ

Shwan будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 1

За последние 30 дней: 5

За всё время: 5,351