Replacement Screen goes blank when waken from idle/timeout.

Question

iPhone 6s

Дата выхода 25 сентября 2015 г. Модель A1688 / A1633. Ремонт данного устройства схож с предыдущими моделями, требующий отвертки и инструменты для вскрытия. Доступен в версиях GSM или CDMA; с 16, 64 или 128 ГБ памяти; в цветах: Серебристый, Золотой, «Серый космос» и «Розовое золото».

2688вопросов Показать все

Robert Ryan @niairo

Репутация: 23

1

Опубликовано: 14 фев 2019 г.

Опции

Replacement Screen goes blank when waken from idle/timeout.

I wonder if anybody can give me a pointer as to what is going wrong my replacement screen for an iphone 6s, when I installed the screen i can get it only to work when the screen is popped out and has no pressure on a certain area of the screen.Once the screen is placed into the frame it works up until the screen goes idle, when its idle I try to wake it up but only the backlight works. I can pop the screen out of the frame it will start working again and once it is out I can put the phone in idle and wake it up without a problem.

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Да Нет

Оценка 1

1 Комментарий

I have a similar situation

24 фев 2019 г. из xkldnamhai.com

Добавить комментарий

1 ответ

Выбранное решение

arbaman @arbaman

Репутация: 102,6к

10

54

291

Опубликовано: 14 фев 2019 г.

Опции

You probably have a mix of a bad quality screen and a bumped housing there and the combination of the two causes that issue. First thing to do would be to try to straighten the housing shape where it’s bumped with a small precision hammer. Or find an original used housing on the market. You could also try reducing a bit the side pressure by gently use very fine sand paper on the screen edges to reduce a bit thickness.

Был ли этот ответ полезен?

Да Нет

Оценка 4

5 Комментариев:

I second this the housing is probably bumped/bent. Which causes pressure on the screen.

14 фев 2019 г. из Lars

The EMI shield pushing against the housing was also causing side pressure. Thanks you very much.

14 фев 2019 г. из Robert Ryan

It's usually just a bad screen. I've used lots of screens on slightly bent frames.

14 фев 2019 г. из Ben

Thank you all, I replaced the screen and it solved the problem.

24 фев 2019 г. из Robert Ryan

@niairo Great, thanks for feedback.

24 фев 2019 г. из arbaman

Добавить комментарий

I second this the housing is probably bumped/bent. Which causes pressure on the screen. — Lars
The EMI shield pushing against the housing was also causing side pressure. Thanks you very much. — Robert Ryan
It's usually just a bad screen. I've used lots of screens on slightly bent frames. — Ben
Thank you all, I replaced the screen and it solved the problem. — Robert Ryan

iPhone 6s

Replacement Screen goes blank when waken from idle/timeout.

1 ответ

Добавьте свой ответ