Перейти к основному содержанию

Repair guides and troubleshooting for the Wizard RT550, a rotary tool made by Black & Decker.

4вопросов Показать все

Accessories not gripped tightly

After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 0
Добавить комментарий

1 ответ

Наиболее полезный ответ

Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.

https://www.ereplacementparts.com/collet...

Был ли этот ответ полезен?

Оценка 2
Добавить комментарий

Добавьте свой ответ

Vince DeLuca будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 5

За последние 30 дней: 10

За всё время: 339