Перейти к основному содержанию

Both Fridge and freeze not cooling, stay warm

My Whirlpool model GSF6C4XY03 side by side

The Freezer started defrost then stay warm, then the Fridge stay warm after that. I unplug it then plug it on back around 4pm, both Freezer and fridge start working back, ice is made. I leave it stay overnight and in the next morning, I saw ice is melted, both stay warm again, not cold at all. I have done twice and the issue is the same. Air is still flown from air duct which stay upper top inside freezer but the air is not cold like usual.

I replace relay, capacitor, clean the coil at the bottom and behind the refrigerator but the issue isn’t fixed.

Temperature is set up at standard : freezer 0F, fridge 37F.

p/s: a few months before, ice maker stop making ice for a day and start make ice again.

Can someone give me the instruction to fix it. Thank you.

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 0
1 Комментарий

Thank you so much. I’ll try

из

Добавить комментарий

1 ответ

Наиболее полезный ответ

It could be a problem with the defrost thermostat. The defrost cycle is a timed event in your case 30 minutes. If all the ice is melted off the evaporator coils then the thermostat should open killing the heater.

The thermostat opens just above freezing.

So if it does not too much heat will be added to the freezer.

If it is deformed/bulged replace it even if it measures OK.

Defrost Thermostat

The defrost thermostat monitors the temperature of the evaporator coils. When the coils drop below a set temperature, the thermostat contacts close to allow power to flow to the defrost heater during the defrost cycle. In the defrost cycle, the defrost heater melts away any frost that may have accumulated on the evaporator coils. If the defrost thermostat is defective, the thermostat contacts will not close. As a result, the thermostat won’t provide power to the defrost heater. To determine if the defrost thermostat is defective, use a multimeter to test it for continuity. If the defrost thermostat does not have continuity when it reaches the low temperature of its operating range, replace it.

Here’s your part:

https://www.repairclinic.com/RepairHelp/...

Был ли этот ответ полезен?

Оценка 1

1 Комментарий:

Thanks Mayor for helping me. After I replace the Defrost Thermostat, my ridge is working well for 2 days. Then the morning of third day ice is melting, the fridge isn’t cool anymore, may be will turn warm the end of the day. Fan still blow air out.

When it works back, the cold air is blown out alot and strong.

please help me again. Thank you

из

Добавить комментарий

Добавьте свой ответ

oanhluu88 будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 1

За последние 7 дней: 2

За последние 30 дней: 12

За всё время: 596