Перейти к основному содержанию

Выпущено 21 сентября 2018 г. Модели A1921, A2101, A2102, A2104. Доступен как GSM, CDMA / eSIM или nano-SIM / 64, 256 или 512 ГБ / серебристый, золотой или космический серый. (Произносится как «iPhone 10 S Max.»)

375вопросов Показать все

iPhone XS Max not turning on

I received an iPhone XS Max which was reported dead and was previously worked on a by a repair store. When I opened the phone I saw 1 missing cap which I guess was pryed off by the old store.

Then Proceeded to separate the board and I find that the top layer is shorted from the CPU running through the PMIC and currently I am clueless.

Any help would be greatly appreciated!


Cheers.

Update (11/11/2020)

Just noted that the U3100 ic and the U5900 ic has been removed and the caps C2721 and C2725 is also removed near the NAND.


Also, C2991 has been removed below the NAND which I suppose is a cap for VDD_MAIN (correct me if i am wrong).

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 0
Добавить комментарий

1 ответ

Hello Myron,

it’s always happens. People buy a phone on ebay, put their screwdrivers in there, their dirty fingers, twist and drill and then sell it as "i look in the morning and it turned off and never turned on again". It is sad that you have come across a dishonest seller. I will try to help, but first question: do you have experience in microelectronics repair?

Firstly, you have to check nad measure main power rail, which is PP_VDD_Main.

Secondly, top layer is independent in this model, so you can power it, if you've made a clear with detached capacitors before - ( c2721 is on SOC_S1 line, that is a PMU buck line - important one - measure here too ).

Finally, plug DCPS, screen panel and prompt to boot by tweezers. Pay attention to what is happening with the power consumption and on the screen. If it's ok, go to the bottom (radio) part of the sandwich.

I hope I helped. As if what, write or email me.

  • regards,

Был ли этот ответ полезен?

Оценка 0

2 Комментариев:

c2721 line has a okay reading, there are many VDD Main capacitors removed and there is u3100 and u5900 remove also.

из

I tried to power up the top layer but it is not consuming any current

из

Добавить комментарий

Добавьте свой ответ

Myron. будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 1

За последние 30 дней: 3

За всё время: 166