Репутация: 1
3
I just replaced the laser in an old gc, and it's moving, but the disk isn't spinning up. Not sure if that was already happening or if it's a new problem though. What can I try now?
Update: took it apart again to check for that solder ball, and now the disc spins, but the laser doesn't turn on
Это хороший вопрос?
Репутация: 551
9
8
13
Go back over the connections you disconnected and make sure they are all connected correctly.
Был ли этот ответ полезен?
Репутация: 2,2к
17
15
5
За последние 24часов: 0
За последние 7 дней: 1
За последние 30 дней: 4
За всё время: 100
2 Комментариев
@sadmango, Did you remove the solder ball all lasers are supposed to be shipped with to make it transport safe?
из Geir Ove Andersen
no, i didn't know there was one
из just some mango