Репутация: 1
2
The brake rotor does not come off after you remove pads and caliber.....is there some bolts on the back side of rotor holding it on. Your comments appreciated
Это хороший вопрос?
Репутация: 782,1к
1,1к
893
2,3к
If it is a two-wheel drive, it should just be slightly pressed on. Sometimes a hammer will do the trick and loosen the rust and grime that may hold it on. If it is 4X4 or AWD :) check for a snap ring on the axle shaft.
Был ли этот ответ полезен?
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 0
За всё время: 574
