Перейти к основному содержанию

1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement

Выберете то, что вам нужно

  1. 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): шаг 1, изображение 1 из 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): шаг 1, изображение 2 из 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): шаг 1, изображение 3 из 3
    • First locate the 4 screws to remove the door panel. See pic1

    • 2 screws are visible.

    • The other 2 screws are behind items.

    • Location of the screws.

    • First screw is under the door lock/window controls. See pic 2.

    • Next screw located lower right of panel behind reflector. See pic 3

    • To remove the door/window controls pry on one end of the controls and lift up. See pic 2.

    • To remove the reflector pry one side and remove from the panel. See pic 3.

  2. 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: шаг 2, изображение 1 из 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: шаг 2, изображение 2 из 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: шаг 2, изображение 3 из 3
    • Before removing panel, remove small tweeter speaker from top of door panel.. Clipped in just pull the top. Pic 1

    • After removing screws, Pull on the panel around the outside to release the pop-in clips.

    • Then remove the panel from the door by lifting up and backward on the panel. Pic 2

    • Be mindful of the rail on top of the panel that may or may not fall off the panel.

    • Also make sure you remove any wires that is connected to the door panel. Lock controls, tweeter speaker wires.

    • On the bottom of the glass inside the door there are two bolts that hold the window to the plastic track on the regulator.

    • Before you remove the second screw hold the window to prevent breakage of the window.

    • While holding the window remove the second screw and lift out the window from the door.

    • Locate and loosen the 4 bolts holding the regulator. See pic 1.

    • Then remove the window regulator motor and all of the track from the door...

    • Then replace the regulator and reverse the procedure to install the regulator back in the door.

Заключение

To reassemble your device, follow these instructions in reverse order.

4 участников успешно повторили данное руководство.

shawn streitmatter

Участник с: 11/25/13

251 Репутация

1 руководство автора

0 Комментариев

Добавить комментарий

Просмотр статистики:

За последние 24часов: 1

За последние 7 дней: 7

За последние 30 дней: 20

За всё время: 8,874