Перейти к основному содержанию

Введение

How to replace or upgrade the Hard Drive.


Please SUBSCRIBE to my channel ツ

Видео обзор

  1. Turn off the laptop and remove the battery. Remove two screws securing the Keyboard. The Keyboard is held by two locking clips, under the battery. Use the sharp tip of a plastic tool to release the keyboard.
    • Turn off the laptop and remove the battery.

    • Remove two screws securing the Keyboard.

    • The Keyboard is held by two locking clips, under the battery. Use the sharp tip of a plastic tool to release the keyboard.

  2. Remove the Keyboard and disconnect the two flex cables: Keyboard flex cable Keyboard Light flex cable
  3. Remove 4x phillips screws and disconnect: Power On button flex cable Touch pad flex cable
    • Remove 4x phillips screws and disconnect:

    • Power On button flex cable

    • Touch pad flex cable

    • Remove 18x Phillips screws from the bottom cover.

    • Remove any memory SD Card from the Card reader.

    • Start opening with a plastic opening tool.

  4. Carefully separate the upper cover and remove it. Carefully separate the upper cover and remove it. Carefully separate the upper cover and remove it.
    • Carefully separate the upper cover and remove it.

  5. Gently remove the HDD and disconnect the SATA cable from it. Please SUBSCRIBE to my channel  ツ Please SUBSCRIBE to my channel  ツ
Заключение

To reassemble your device, follow these instructions in reverse order.

31 участников успешно повторили данное руководство.

ZFix

Участник с: 09.12.2013

179 910 Репутация

Автор 323 руководств

Команда

Master Techs Участник Master Techs

Community

300 членов

Автор 1 005 руководств

Комментариев: 6

Good job! What a pain, though, to swap the HDD :)

Steve Wojciechowski - Ответить

I am currently working on this laptop and it doesn't open at all like this one. This is only one back... and 18 screws holding it on. I can partially snap the back off but i can't pry it apart by the dvd drive. I'm also guessing the same model is manufactured differently for different retailers. (This happens in the retail hardware world where a dewalt drill from home depot will be made cheaper than a dewalt from ace hardware) so now I"m stuck. any ideas would be helpful. thanks.

FallenAnjel - Ответить

ok found the problem. i accidentally popped out the dvd drive (when I was just trying to open it lol) and up under the lip I found three 1/8" long very-flat head screws. unscrewed those and the back came right off.

FallenAnjel - Ответить

New customer that does like shopping local with recommended proprietors and stockiest of the required components.

Thank you Mr Jason Paul Cominelli.

Jason Paul Cominelli - Ответить

are 9mm hard disk can fit?

the original was 7mm

jason.chiah1008 - Ответить

Добавить комментарий

Просмотр статистики:

За последние 24часов: 7

За последние 7 дней: 47

За последние 30 дней: 213

За всё время: 65,039