Перейти к основному содержанию

Эта версия возможно содержит некорректные исправления. Переключить на последнюю проверенную версию.

Выберете то, что вам нужно

  1. Этот шаг не переведен. Помогите перевести

    : шаг 1, изображение 1 из 1
    • Remove broken key(s) using the flat end of spudger.

    • When working with electronics, it's important to choose a tool that's ESD-safe to avoid accidental damage to the device. The regular spudger and tweezer should be used whenever possible.

    • When reinstalling the key, no spudger is needed. Just pop it into place with fingers.

  2. Этот шаг не переведен. Помогите перевести

    : шаг 2, изображение 1 из 2 : шаг 2, изображение 2 из 2
    • Using the flat end of the spudger, very carefully lift up the corners of the cradle.

    • With the help of tweezers (needle nose works best), pull the hooks of the cradle out.

    • For re-installation of the plastic piece use tweezers to put it back in place and pop the bottom half in before the top.

Финишная черта

4 участников успешно повторили данное руководство.

Tony

Участник с: 01/20/16

459 Репутация

Автор 2 руководств

Команда

USF Tampa, Team 10-5, Remmell Spring 2016 Участник USF Tampa, Team 10-5, Remmell Spring 2016

USFT-REMMELL-S16S10G5

3 членов

Автор 8 руководств

Один комментарий

no help i need help putting it on with out that

Simon Kuhn - Ответить

Добавить комментарий

Просмотр статистики:

За последние 24часов: 2

За последние 7 дней: 15

За последние 30 дней: 80

За всё время: 7,146