Введение
This guide will show you how to adjust the height of the handle bars and align the stem with the front wheel.
Выберете то, что вам нужно
-
-
Remove the bolt cover with a flathead screwdriver.
-
-
-
-
Loosen the goose-neck (adjustable quill stem) with a 6 mm Allen wrench.
-
After loosening the goose-neck (adjustable quill stem), it still may be stiff. Hold the wheel from turning and twist the handlebars from side to side.
-
If quill stem is still stuck then place 6 mm Allen wrench firmly into bolt and tap with a mallet.
-
Position the handlebars to your preferred height. Make sure not to pull cable and housing to tight. I could adversely effect shifting and braking performance.
-
Make sure you don't raise quill stem above minimum insert line.
-
-
-
Align the direction of the goose-neck (adjustable quill stem) with the front tire.
-
Firmly tighten the goose-neck (adjustable quill stem) bolt using a 6 mm Allen wrench.
-
Pop the bolt cover back on.
-
If calling a bicycle repair shop, refer to it as a adjustable quill stem (technical term) instead of goose-neck as mechanic may not know what you are talking about.
-
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.
Команда
Cal Poly, Team 5-13, Maness Fall 2010 Участник Cal Poly, Team 5-13, Maness Fall 2010
CPSU-MANESS-F10S5G13
4 членов
Автор 17 руководств
