Перейти к основному содержанию

Введение

Use this guide to replace the hook-and-loop sandpaper disc on a Clarke Floor Sander 07163A 2012.

This guide shows the removal of just one disc, but the procedure for the other two discs is identical.

  1. Before you begin, be sure that the sander is unplugged and powered off.
    • Before you begin, be sure that the sander is unplugged and powered off.

    • Carefully tilt the sander back and lay it down on its side, exposing the three sanding pads on the bottom.

  2. Peel the hook-and-loop sandpaper disc off of the driver assembly.
    • Peel the hook-and-loop sandpaper disc off of the driver assembly.

Заключение

To reassemble your device, follow these instructions in reverse order.

Miles Robinson

Участник с: 04.03.2019

839 Репутация

Автор 7 руководств

Команда

The Home Depot Участник The Home Depot

Community

6 774 членов

Автор 1 008 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 22