Этот документ имеет более свежие изменения. Перейти к последней непроверенной версии.
Выберете то, что вам нужно
-
-
Use screwdriver to gently pry off the stickers marked in red to reveal the location of the 4 screws
-
-
-
Pry the center of the mouse apart to separate upper and lower housing of the boards.
-
-
-
Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.
-
-
-
Take the upper housing of the mouse and remove the two screws (highlighted in red) that hold the board in place.
-
-
-
The LED is the red component on this board circled in red.
-
To remove it, flip the board over and desolder the wired highlighted in orange.
-
Replace LED with a new LED and resolder into place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.