Этот документ имеет более свежие изменения. Перейти к последней непроверенной версии.
Выберете то, что вам нужно
-
-
Use the screwdriver to pry off the stickers marked in red to reveal the location of 4 screws.
-
-
-
Use a flat head screw driver to pry apart the upper and lower housing of the mouse.
-
-
-
-
Pull the wires from the white crimping headers to disconnect them, separating the top from bottom.
-
-
-
The IC (Integrated Circuit) is highlighted in red, it is the mouse sensor.
-
Desolder the 6 wires holding the IC in place to complete the sensor change.
-
Replace component with new component and resolder back in place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
2 участников успешно повторили данное руководство.