Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Введение

This is how to remove the 5 screws and pry the logic board free.

Запчасти

Детали не указаны.

  1. Hold the phone in one hand, slide latch, and pull to remove the battery. Hold the phone in one hand, slide latch, and pull to remove the battery.
    • Hold the phone in one hand, slide latch, and pull to remove the battery.

  2. Grasp antenna at its base and unscrew. Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly. Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.
    • Grasp antenna at its base and unscrew.

    • Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.

  3. Manta Driver Kit

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta Driver Kit

    Upgrade Your Toolbox
  4. Remove the small rubber insert from the top of the phone to access the top screw. Warning: Screws are very small and may be difficult to see while unscrewing. Unscrew all five (5) screws on the back of cell phone.
    • Remove the small rubber insert from the top of the phone to access the top screw.

    • Warning: Screws are very small and may be difficult to see while unscrewing.

    • Unscrew all five (5) screws on the back of cell phone.

    • If screws do not remove after fully unthreading, gently invert and tap phone in hand until the screws come loose.

  5. Wedge back plate away from cell phone using the leverage from the plastic spudger. The volume control button on the left side of the phone will be loose. Make sure to carefully reinsert during reassembly. Detach logic board from LCD screen connector by gently detaching the small copper plate on the top right of the logic board (shown circled in blue and detached).
    • Wedge back plate away from cell phone using the leverage from the plastic spudger.

    • The volume control button on the left side of the phone will be loose. Make sure to carefully reinsert during reassembly.

    • Detach logic board from LCD screen connector by gently detaching the small copper plate on the top right of the logic board (shown circled in blue and detached).

  6. Pop the logic board out from the front of the cell phone. Before reassembly, be sure keypad is lined up with logic board. Before reassembly, be sure camera lens is properly aligned at the top of the logic board and volume controls are in place.
    • Pop the logic board out from the front of the cell phone.

    • Before reassembly, be sure keypad is lined up with logic board.

    • Before reassembly, be sure camera lens is properly aligned at the top of the logic board and volume controls are in place.

Заключение

To reassemble your device, follow these instructions in reverse order.

Еще один человек закончил это руководство.

Aaron Shaw

Участник с: 15.04.2010

150 Репутация

Автор 6 руководств

Команда

Cal Poly, Team 28-31, Regan Spring 2010 Участник Cal Poly, Team 28-31, Regan Spring 2010

CPSU-REGAN-S10S28G31

4 членов

Автор 12 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 2,613