Введение
Both front and back cameras are connected as a single assembly and must be replaced together.
Выберете то, что вам нужно
-
-
Use a plastic opening tool to pry the back panel off by inserting it in between the front and back panel.
-
-
Инструмент, используемый на этом этапе:Tweezers$4.99
-
Remove the battery connector using either your fingers or a pair of tweezers.
-
-
-
Unscrew two 1.17x2.9mm Phillips screws from the white connector port.
-
Lift the battery connector away from the motherboard using a spudger.
-
-
-
Remove the flat-top connector coming from across the camera assembly with a spudger.
-
-
-
-
With the spudger, remove the flat-top connector coming from underneath the motherboard.
-
-
-
Remove the clipped ZIF data connector coming from underneath the motherboard.
-
Lift up the black plastic clip with a spudger.
-
Pull the connector out gently using tweezers.
-
-
-
Remove the following five screws from the motherboard.
-
Three 1.5x2.5mm Phillips screws
-
Two 1.55x2.38mm Phillips screws
-
-
-
Lift all four antenna connectors from the motherboard again using the spudger.
-
-
-
Gently lift the motherboard away from the device. If there is any resistance, check the previous steps to ensure that all connections have been removed.
-
-
-
Use a spudger to detach the flat-top connector from the camera assembly.
-
-
-
Pry the camera assembly away from the device, lifting the left side with a spudger.
-
-
-
Insert spudger between the plastic frame and circuit board.
-
Gently pry the plastic frame away from the rest of the camera assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
2 человек успешно провели ремонт по этому руководству.