Введение

The side paneling is the plastic that protects the inside of the printer. This guide will teach you how to effectively remove the paneling without cracking it.

Запчасти

Никакие детали не требуются.

Lift the printer lid up as shown in the photo.
  • Lift the printer lid up as shown in the photo.

Добавить комментарий

Locate and remove the two 10mm side screws. There is one on each side. Locate and remove the two 10mm side screws. There is one on each side.
  • Locate and remove the two 10mm side screws. There is one on each side.

Добавить комментарий

Unhook the plastic panel from the printer starting from the top. You may need to wiggle the panel a bit to loosen it.
  • Unhook the plastic panel from the printer starting from the top.

    • You may need to wiggle the panel a bit to loosen it.

  • To remove the bottom part of the paneling gently lay the printer on its back.

    • The scanner lid needs to be supported when moving the printer

Добавить комментарий

Gently unhook the right side paneling (as looking at the printer's front face) from the printer. Use a gentle back and forth motion to wiggle the hooks out. Use a gentle back and forth motion to wiggle the hooks out.
  • Gently unhook the right side paneling (as looking at the printer's front face) from the printer.

    • Use a gentle back and forth motion to wiggle the hooks out.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

2 участников успешно повторили данное руководство.

Helena Yanez

Member since: 29.09.2013

446 Репутация

Автор 4 руководств

Команда

Cal Poly, Team 13-1, Forte Fall 2013 Member of Cal Poly, Team 13-1, Forte Fall 2013

CPSU-FORTE-F13S13G1

5 членов

Автор 8 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 2

За 7 дней: 4

За 30 дней: 24

За всё время: 2,309