Перейти к основному содержанию

Введение

Follow this guide to replace the flash of your Canon Powershot Pro1. Nearly every camera on today’s market is equipped with a flash. The flash allows the user to take high quality pictures in poorly lit conditions and capture quickly moving objects. This guide will detail the steps necessary to replace the flash bulb and capacitor. The flash capacitor is capable of storing large amounts of energy. Therefore, it is important to remove the battery prior to disassembly. The capacitor can be discharged by pressing the flash Also, be sure to use ESD safe tools.

Запчасти

Детали не указаны.

  1. Locate the battery compartment cover on the right hand side of the camera. The cover features the text: “CF/BATT.OPEN”.
    • Locate the battery compartment cover on the right hand side of the camera. The cover features the text: “CF/BATT.OPEN”.

  2. There is an arrow beside the text. Using your hands, slide the cover in the direction of this arrow.
    • There is an arrow beside the text. Using your hands, slide the cover in the direction of this arrow.

  3. Pull the cover toward you. After doing so you will see the battery sitting inside the compartment
    • Pull the cover toward you. After doing so you will see the battery sitting inside the compartment

  4. Press the battery lock. It is an orange button on the inside of the compartment.
    • Press the battery lock. It is an orange button on the inside of the compartment.

    • After pressing the battery lock, you will be able to remove the battery. NOTE: This photo displays the battery compartment after the battery has been removed.

  5. Remove the 25.4 mm Phillips #0 flash screw. The screw is near the flash. Be careful not to damage the screw.
    • Remove the 25.4 mm Phillips #0 flash screw. The screw is near the flash.

    • Be careful not to damage the screw.

  6. Locate the small points on both sides of the lens.
    • Locate the small points on both sides of the lens.

    • Pry the lens housing using the black nylon spudger so that it is lifted out of these points.

    • Don't use a screwdriver as a prying tool, this could cause damage.

  7. Use the plastic spudger to remove the upper portion of the flash housing.
    • Use the plastic spudger to remove the upper portion of the flash housing.

  8. Use the nylon spudger to dislodge the flash bulb and capacitor from the housing. Don't use a screwdriver as prying tool, this could cause damage. Don't use a screwdriver as prying tool, this could cause damage.
    • Use the nylon spudger to dislodge the flash bulb and capacitor from the housing.

    • Don't use a screwdriver as prying tool, this could cause damage.

  9. Cut the flash and capacitor cables with a wire cutter.
    • Cut the flash and capacitor cables with a wire cutter.

Заключение

To reassemble your device, follow these instructions in reverse order.

Seana Meegan

Участник с: 06.09.2019

639 Репутация

Автор 5 руководств

Команда

University of Alabama, Team S1-G1, Bedsole Fall 2019 Участник University of Alabama, Team S1-G1, Bedsole Fall 2019

UA-BEDSOLE-F19S1G1

3 членов

Автор 10 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 2

За последние 7 дней: 3

За последние 30 дней: 12

За всё время: 258