Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Введение

Swapping out the presser foot lets you create different stitches for different sewing tasks, such as buttonholes, zippers, zigzag, etc. Use this guide to change the presser foot in your sewing machine. We’re using a Bernina 830 for this procedure; sewing machines can vary, so check your sewing machine's owner’s manual for specific instructions.

Инструменты

Инструменты не указаны.

Запчасти

  1. Set the sewing machine needle to the upright position by turning the balance wheel towards you. Release the presser foot lever by sliding it up.
    • Set the sewing machine needle to the upright position by turning the balance wheel towards you.

    • Release the presser foot lever by sliding it up.

    • The presser foot will just fall out. Be ready to grab it.

  2. Pull the presser foot down and slide it off the peg on the machine. Be careful not to break the needle. Be careful not to break the needle.
    • Pull the presser foot down and slide it off the peg on the machine.

    • Be careful not to break the needle.

  3. Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits

    Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits
  4. Grab your desired presser foot, and orient it foot-down. Take the foot at an angle and slide the hole in the top of the presser foot onto the peg on the sewing machine. Take the foot at an angle and slide the hole in the top of the presser foot onto the peg on the sewing machine.
    • Grab your desired presser foot, and orient it foot-down.

    • Take the foot at an angle and slide the hole in the top of the presser foot onto the peg on the sewing machine.

  5. Slide the presser foot lever down to lock the new foot in place. Be sure to check your manual to see if you need to adjust the needle position. If it's not correctly adjusted, you may hit the needle on the presser foot and break the needle while sewing.
    • Slide the presser foot lever down to lock the new foot in place.

    • Be sure to check your manual to see if you need to adjust the needle position. If it's not correctly adjusted, you may hit the needle on the presser foot and break the needle while sewing.

Финишная черта

Еще один человек закончил это руководство.

Brittany McCrigler

Участник с: 05.03.2012

83 076 Репутация

Автор 132 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 19

За последние 7 дней: 181

За последние 30 дней: 679

За всё время: 22,749