Skip to main content
  1. Flip your bike so the seat and handlebars are on the ground.
    • Flip your bike so the seat and handlebars are on the ground.

  2. Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.
    • Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.

    • Make sure that the chain is on the correct side of the wheel

  3. Комплект инструментов для замены батареи Macbook

    Доступно с $69.99

    Buy Now

    Комплект инструментов для замены батареи Macbook

    Доступно с $69.99

    Buy Now
  4. Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.
    • Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.

  5. Center the wheel and pull back to tighten the chain
    • Center the wheel and pull back to tighten the chain

  6. With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.
    • With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.

    • Wheel will angle as you tighten. Keep it centered with your hand as you finish tightening both axle nuts.

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Erin Heimburge

Участник с: 11.07.2013

30 Репутация

1 Guide authored

Команда

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 5

За 7 дней: 24

За 30 дней: 111

За всё время: 5,902