Перейти к основному содержанию

De Longhi Heater temperature Sensor

  1. De Longhi Heater temperature Sensor, Temperature Sensor: шаг 1, изображение 1 из 1
    • Heater unit bricked with PF error (fault temperature sensor)

  2. De Longhi Heater temperature Sensor: шаг 2, изображение 1 из 1
    • Remove the four Phillips screws with a Phillips screwdriver

    • Remove the remaining 2 screws with a Torx screwdriver

    • Remove the cover

  3. De Longhi Heater temperature Sensor: шаг 3, изображение 1 из 1
    • Open the clamps by unhooking them with pliers or using a flathead screwdriver.

  4. De Longhi Heater temperature Sensor: шаг 4, изображение 1 из 1
    • Unscrew the Phillips screw to remove the temperature sensor.

  5. De Longhi Heater temperature Sensor: шаг 5, изображение 1 из 1
    • Unclip the temperature sensor connector from the motherboard.

  6. De Longhi Heater temperature Sensor: шаг 6, изображение 1 из 1
    • The temperature sensor had broken because it was corroded by moisture.

  7. De Longhi Heater temperature Sensor: шаг 7, изображение 1 из 2 De Longhi Heater temperature Sensor: шаг 7, изображение 2 из 2
    • With a soldering iron I proceeded to weld the broken part and to connect the 2 tracks by applying electric wire and some tin.

    • If the component can not be repaired, you can find the complete electronic board replacement on eBay

Заключение

To reassemble your device, follow these instructions in reverse order.

3 участников успешно повторили данное руководство.

Особая благодарность этим переводчикам:

it en

100%

Эти переводчики помогают нам починить мир! Хотите внести свой вклад?
Начните переводить ›

Smilzo

Участник с: 11/09/13

11 240 Репутация

Автор 39 руководств

0 Комментариев

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 6

За последние 30 дней: 79

За всё время: 4,336