Введение

Use this guide to remove the front and rear cover of the Canon PowerShot SD1100 IS.

Запчасти

Никакие детали не требуются.

Remove wrist strap and battery.
  • Remove wrist strap and battery.

Добавить комментарий

Remove 2 screws from each side of the camera (4 total, 0.102 in).
  • Remove 2 screws from each side of the camera (4 total, 0.102 in).

  • Remove 2 screws from the bottom on the camera (0.138 in).

  • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Добавить комментарий

  • Gently pull off the front cover.

  • The plate on the side should come off.

  • Gently pull off the back cover.

Добавить комментарий

  • The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - Ответить

oh yes , i agree lol

elbala80 -

Заключение

To reassemble your device, follow these instructions in reverse order.

2 участников успешно повторили данное руководство.

Tyler Grossheim

Участник с: 25.01.2011

1 359 Репутация

Автор 6 руководств

Команда

Cal Poly, Team 3-32, Regan Winter 2011 Member of Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 членов

Автор 8 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 2

За всё время: 3,143