Введение

The LCD display can be removed and replaced if it is cracked or broken.

Запчасти

Никакие детали не требуются.

Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen. Remove the 2 screws(4.08mm) on the other side.  One is located under the rubber USB flap. Remove the last screw(2.59mm) located on the bottom of the camera.
  • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

  • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

  • Remove the last screw(2.59mm) located on the bottom of the camera.

  • Slowly pull the back cover of the camera.

Добавить комментарий

Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen. Disconnect the ribbons connecting the screen to the camera. Remove the screen by lifting it off.
  • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

  • Disconnect the ribbons connecting the screen to the camera.

  • Remove the screen by lifting it off.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Ben Tupas

Member since: 13.01.2011

317 Репутация

Автор 3 руководств

Команда

Cal Poly, Team 13-3, Forte Winter 2011 Member of Cal Poly, Team 13-3, Forte Winter 2011

CPSU-FORTE-W11S13G3

5 членов

Автор 8 руководств

Один комментарий

Hm. "Disconnect the ribbons" resulted in a torn ribbon, and so a dead camera, I think. This also doesn't say how to take the LCD screen out of its frame. Alas.

Maelduin - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 0

За всё время: 2,145