Disassembling Compaq Mini 110 Hard Drive

Этот документ имеет более свежие изменения. Перейти к последней непроверенной версии.

Выберете то, что вам нужно

Шаг 1 Battery

Disassembling Compaq Mini 110 Hard Drive, Battery: шаг 1, изображение 1 из 2

Disassembling Compaq Mini 110 Hard Drive, Battery: шаг 1, изображение 2 из 2

Locate the battery and the battery tabs on the bottom of the Compaq Mini.

Редактировать

Шаг 2

Disassembling Compaq Mini 110 Hard Drive: шаг 2, изображение 3 из 3

Push both tabs inward simultaneously and slide the battery out.

Редактировать

Шаг 3 RAM

Disassembling Compaq Mini 110 Hard Drive, RAM: шаг 3, изображение 1 из 2

Disassembling Compaq Mini 110 Hard Drive, RAM: шаг 3, изображение 2 из 2

Use a Philips #0 screwdriver to unscrew the two screws covering the memory compartment on the bottom of the laptop and remove the cover.

Редактировать

Шаг 4

Push out the side tabs simultaneously and pull out the old RAM module.
When inserting a new RAM stick, be sure to evenly insert the gold pins in the same orientation that the old module was removed. While sliding the module in, press the side tabs in place.

Редактировать

Шаг 5 Keyboard

Disassembling Compaq Mini 110 Hard Drive, Keyboard: шаг 5, изображение 1 из 2

Disassembling Compaq Mini 110 Hard Drive, Keyboard: шаг 5, изображение 2 из 2

Remove the rubber pads located on the corners of your Compaq Mini.
There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Редактировать

Шаг 6

Unscrew all the corner screws. There are four total, one under each rubber pad.

Редактировать

Шаг 7

Unscrew the screw for the bottom case located in the RAM compartment.

Редактировать

Falta um passo, pois nos modelos COMPAQ MINI 110, existe um parafuso que segura o teclado, que se encontra bem escondido dentro da cavidade que encaixa a bateria.

Amilcar Correia - 24 мая 2011 г. Ответить

Шаг 8

Remove the three screws in the silver tabs at the back of the keyboard.
These are located at the back of the base under the screen.
Lift the keyboard away from the laptop.

Редактировать

3 screws in red circles are actually on metal tabs in the battery compartment, 1 deeper than the other 2. There is a keyboard symbol for each of the 3 screws.

Step 8B: Lift out keyboard by pushing upwards on the 2 accessible metal tabs. This is the most difficult step. Lack of Quality Control during assembly may prevent the kevboard from lifting out without breaking!!

John - 26 мая 2012 г. Ответить

This step may be performed after battery removal. Use care when removing ribbon cable: the white clips holding the black plastic "keeper" are fragile. Reassembly possible without white clips; however, jostling may cause the ribbon to come free.

Jason L - 14 дек 2014 г. Ответить