Введение

This guide will explain step by step how to remove the outer cases of the IBM WorkPad c3.

Запчасти

Никакие детали не требуются.

  1. Turn the device over so that the screen is facing down. In the next step the device will be heated, so the screen must be turned over to prevent heat damage to the LCD/Digitizer.
    • Turn the device over so that the screen is facing down.

    • In the next step the device will be heated, so the screen must be turned over to prevent heat damage to the LCD/Digitizer.

  2. Free shipping on all orders over 100,00 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  3. Using a hair dryer, slowly heat the edges of the WorkPad.
    • Using a hair dryer, slowly heat the edges of the WorkPad.

    • Spend at least one minute heating each side of the device. This will melt the glue holding the case together, and allow it to be removed.

    • Be sure not to touch the device directly after heating as it will be extremely hot. Use a towel or oven mitt to grab it.

  4. Use a plastic opening tool to pry the back case from the WorkPad. If the rear cover is not coming off very easily, you probably need to reheat the case in order to sufficiently melt the glue.
    • Use a plastic opening tool to pry the back case from the WorkPad.

    • If the rear cover is not coming off very easily, you probably need to reheat the case in order to sufficiently melt the glue.

Заключение

To reassemble your device, follow these instructions in reverse order.

Emily Falkenstein

Участник с: 05.10.2010

51 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 21-35, Regan Fall 2010 Member of Cal Poly, Team 21-35, Regan Fall 2010

CPSU-REGAN-F10S21G35

3 членов

Автор 5 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 1

За всё время: 1,242