Введение

It is the first step in repairing the internal components of the cube.

Запчасти

Никакие детали не требуются.

  1. Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.
    • Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.

    • Push back the handle after you have taken the core out of the case.

  2. Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
    • Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.

    • Slowly lift the plate off the cube and disconnect the power cord.

    • Remove the four pillars from each corner.

    • The pillars should come out fairly easily.

Заключение

To reassemble your device, follow these instructions in reverse order.

6 участников успешно повторили данное руководство.

Ryan Chun

Участник с: 24.06.2010

674 Репутация

Автор 7 руководств

Команда

Cal Poly, Team 2-7, Johann Summer 2010 Member of Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 членов

Автор 7 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 2

За 7 дней: 8

За 30 дней: 37

За всё время: 9,167