Drawer Roller Bracket Replacement

Введение

This project will result in an illustrated how-to guide on fixing a drawer roller bracket that does not close completely. By the end of this fix you will have a drawer that closes flush against the face of the furniture.

Выберете то, что вам нужно

Шаг 1 Drawer Roller Bracket Replacement

Drawer Roller Bracket Replacement, Drawer Roller Bracket Replacement: шаг 1, изображение 1 из 2

Drawer Roller Bracket Replacement, Drawer Roller Bracket Replacement: шаг 1, изображение 2 из 2

Clear out drawer of any contents. This will make the drawer easier to handle, with no mess or clutter.
To remove, pull the drawer completely open.
Lift the drawer straight up.

Редактировать

Шаг 2

Remove the brackets on the drawer.
Some may have rivets, some may have screws. If there are screws a simple screwdriver will do the trick. If there are rivets use a drill the size of the head of the rivet and proceed to drill the head of the rivet.
When removing rivets with a drill, wear eye protection and be cautious.

Редактировать

Шаг 3

Measure the length of the internal track to the recessed part in the rear of the track.
This recess will hold the drawer completely closed when the wheel on the bracket reaches it.
Then measure the amount of bracket that needs to be removed. In our case, 2 inches will need to be removed.

Редактировать

Шаг 4

Remove the excess bracket. Make sure to remove parts of the bracket that do not contain holes. These holes are used for fasteners.
To cut a section, make sure you make perfectly vertical cuts for the remaining pieces to line up. To assure a straight line to cut, use a sharpie marker to mark a straight line.
Use a reciprocating power saw or a grinder with cutting wheel. I used a grinder because I found it to be easier.
Maintain eye protection, and gloves if necessary.

Редактировать

Шаг 5

Apply JB Kwikweld to the remaining pieces of bracket. Mix equal parts of the mixture.
Discard the removed piece from last step.
When applying JB weld, use a small amount, I used a toothpick as an applicator.
Set time was roughly 6 minutes for the weld mixture to set.
Before adding weight to the drawer, allow the weld to fully cure. This will take 4-6 hours.

Редактировать

Шаг 6

Use a drill with a drill bit to make necessary holes for screws to sit and fasten the bracket. Use a drill bit slightly larger than shaft of screws, but smaller than the head of the screws.
I used a 3/32 drill bit.
Install new fastener screws to the bracket.
My build required 12 #6x1/2inch Philips screws. I used three screws on each end of the brackets and six screws on each end of the bracket.
The more screws used, the stronger the bracket is secured. (Two on the bottom of the bracket, and one on the inside of the track.)
If possible, use preexisting holes, and screws.
Sometimes screws protrude too far, you may have to grind the head of the screw slightly so it protrudes less.

Редактировать

Шаг 7

Make sure the bracket is fastened securely, make any necessary adjustments.
You may need to grind down some of the JB Weld if too much was applied. Simply used a file or grinder.

Редактировать

Шаг 8

Insert wheels on both sides of the drawer bracket into the opening behind the wheel on the track located in the furniture.
Close the drawer and make sure it opens and closes functionally.

Редактировать