Перейти к основному содержанию
  1. Remove the six 13 mm casing screws with the #0 Phillips screwdriver.
    • Remove the six 13 mm casing screws with the #0 Phillips screwdriver.

  2. Separate the screwdriver casing halves with the plastic opening tool. Separate the screwdriver casing halves with the plastic opening tool.
    • Separate the screwdriver casing halves with the plastic opening tool.

  3. Slide the bit chuck assembly out from the casing half.
    • Slide the bit chuck assembly out from the casing half.

  4. Apply a dab of grease to the end of the drill motor coupler.
    • Apply a dab of grease to the end of the drill motor coupler.

  5. Insert new bit chuck assembly into the drill casing.
    • Insert new bit chuck assembly into the drill casing.

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Tyler Vincent

Участник с: 24.02.2014

428 Репутация

Автор 4 руководств

Команда

Michigan Tech, Team 5-5, Lauer Spring 2014 Member of Michigan Tech, Team 5-5, Lauer Spring 2014

MTU-LAUER-S14S5G5

3 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 1

За 30 дней: 3

За всё время: 333